Idex Hale Sam, Technical Manual

Page: 103 / 223

83
4.7.5.1 Gearbox Temperature Sensor
If a gearbox temperature sensor fails or is damaged, replace the sensor as follows.
See Figure 52.
Removal
A.
Note cable tie locations, cut ONLY ties required to R&R sensor.
B. At sensor, tag and disconnect electric connector.
C. Remove sensor.
Figure 52. Gearbox Temperature Sensor
Installation
A.
Apply Loctite 580 to threads of new sensor.
B. Install sensor.
C. Connect electric connector according to tags.
D. Install cable ties cut to R&R sensor as noted.
4.7.5.2 Pump Temperature Sensor
If a pump temperature sensor fails or is damaged, replace the sensor as follows.
See Figure 53.
Removal
A.
Note cable tie locations, cut ONLY ties required to R&R sensor.
B. At sensor, tag and disconnect electric connector.
Figure 53. Pump Temperature Sensor