FAST & FLUID MANAGEMENT srl
A Unit of Idex Corporation
1155432B-it,en,de.doc
– 21/07/2010
28
The two mobile plates move untill the can is pressed . After about 2 seconds the mixing cycle begins at slow
velocity. After 5 seconds the velocity of the can increases until it reaches the desired mixing velocity.
When the set time is expired the rotation velocity decreases
After the deceleration phase the machine stops.
When the stirring cycle is finished and the can is motionless the two plates open and it is now possible to extract
the can.
N.B.
It is not possible to perform the mixing cycle at the maximum velocity with cans which weighs more
than 10 Kg.
Pushing the or or keys, the machine indicates an error (E-7) and automatically the
machine begins to operate at slow velocity
3) If the can to be mixed is higher than the opening clearance of the plates, it is necessary to open the distance
between the plates pushing key before opening the door/shutter.
7) To stop the mixer during non-emergency situation, press the STOP key .
Unless necessary, please do not use the emergency push button .
8) If during the functioning of the Mixer Ferraris the emergency push button is pushed down, push the key
STOP before starting a new mixing cycle. Failure to do so will generate an error (E-4) when pressing the
or or keys.
N.B.
After pushing the emergency button, before activating any operation please wait till the cradle stops completely.
9) When the mixing cycle is finished, remember not to keep the can inside the basket
a) If the power supply is off when the plates block the can, wait for the setting of the line and the cradle will
position itself automatically
b If the power supply is off with the can inside , switch off the main switch and take away the can.
If the door/shutter is closed, turn off the switch, open the door/shutter as indicated in the “EMERGENCY
DOOR/SHUTTER OPENING” and take away the can.
7) Avoid to go on pressing and releasing key
EMERGENCY DOOR/SHUTTER OPENING
In case of malfunctioning or absence of power supply the door/shutter is blocked.
To open the door/shutter operate as follows
:
Insert the point of a screw-driver under the
sliding door/shutter guide ( as indicated)
Push the block-pin and pull the door/shutter to
the right.
