MT-50 Multitouch Table DIY Building Instructions–Version 1.2 - 4/5/11 - Page 12
An i7 is not necessary, but at least a quad core of some sort is
recommended.
2GB of RAM will work, but a minimum of 4GB is recommended.
Hard drive space is at the builder’s discretion. If you plan on having a lot of
media, go for large drives. If you are worried about redundancy, double
the drives up and set up a RAID.
Most tracking software still runs on Windows XP, so that could also be an
option for the OS.
The power switch on the computer case has been disconnected and
hooked directly into the blue LED power switch on the bottom of the
table.
On most computer system boards, there should be 2 pins for On/Off
power button function, and 2 pins for LED power for the On/Off buttons.
Refer to the system board manual to locate those pins.
The power switch on the MT-50 is located on the bottom 2-gang panel that
also has the USB, Audio, HDMI, and RJ-45 connections on it.
Summary of Contents for MT-50
