DMI-F-04_Annexe 3_Notice 1.0 RAJOUTER CODE ERREUR
13
DESCRIPTION DU PRODUIT
A - base
B - frame
C - electric actuator
D - width adjusting pedal
E - control box with battery,
F - remote control
G - lifting arm
H - adjusting screw
I – hanger
J - front castor without brake
K - rear castor with brake
L - base
SAFETY PRECAUTIONS
Failure to follow the safety precautions may result in the risk of serious injury.
Do not exceed the maximum weight limit of 150 Kg.
Do not ued a device to transport patients overs long distances.
Choose the sling recommended by the doctor for the patient. When moving the patient while he is suspended from a
carrier attached to the lift,Do not move the base wheels through items such as raised carpet frames, door sills, or any
uneven surfaces that may cause the lift to shake. If any undesirable effects occur, the patient's transport should be
stopped immediately.
Check that the product contains all the parts
Make sure that all components do not have visible mechanical damage. In case of doubt, contact the manufacturer.
Do not use the device until all components are properly connected.
Please do not place the hoist on an inclined surface as it may fall down
Do not attempt to exceed any steps, curbs, or other obstacles that could cause injury or injury when the product falls
over.
Do not attempt to repair the battery yourself
Using the lifting device on an unstable surface (covered with ice, wet, greasy, sandy) is unacceptable- it causes risk of
falling,
You can only use the lifting device on surfaces where all four wheels are touching the ground.
Do not leave the lifting device with the user close to open sources of fire.
Be aware that the surface temperature of the frame parts may be increased after exposure to the sun or other heat
source. Furthermore, with low temperatures there is a danger of overcooling metal parts of lifting device. It may cause
burns or frostbite parts of the body,
In order to transfer lifting device, grab the frame. Never transfer the lifting device by grabbing movable elements or
control unit.
Lifting device must be easy to fold and to unfold. In case of problems with folding, you should re-read the instruction or
contact the manufacturer.
Brakes cannot slow down the lifting device during ride, you should use them only to prevent the unintended movements.
Oil, grease, water or other chemicals, may cause that brakes may have reduced effectiveness
It is extremely important to keep all lifting devices components clean in order to maintain the product parameters.
Do not use the lifting device after discovering any visible or detectable damages or when the wear of some parts may
cause an accident. All the repairs need to be performed by skilled personnel and during the warranty period only by the
manufacturer's service.
During transport (e.g. In the trunk), do not burden lifting device elements, it may weaken or damage its structure.