iPOINT – Hardware User Manual | 18.06.2020
Copyright © 2020 IDENTEC SOLUTIONS. All rights reserved.
17
3. Initial Operation / Configuration
The configuration of the iPOINT is managed via the host software.
Available Identec Solutions Software
Setup Scout
i-Share
Crew Companion
Please refer to the relevant software User Manuals for details.
3.1 Status LEDs
UHF
This is the UHF Communication LED. LED blinks green when a
valid command has been sent to Tag. It blinks Orange when a
response or a broadcast is received.
LF
This is the LF Communication LED. LED blinks green when
Marker Loop ID is sent. It blinks red if LF is not working properly
(e.g. loop broken or loop current too low).
COM
This is the wired interface LED. It blinks green when a command
is received and orange when responding over RS422 or RS485.
Note: Because of short communication you can see just the
orange blink.
RUN
This is the general Device run LED. It blinks Green if everything
is OK. Blinks red if the voltage is too low or a Hardware issue is
detected
NFC (top)
This is the NFC Card read LED. Is green when access is granted,
red when access is denied.
