i-B2X W
Page 5 of 11
2
Introduction
2.1
Preparations
This installation manual must be read carefully prior to starting the installation. The described installation
works assume that installation materials like cable, antenna and tag holder etc are available.
2.2
Recommended Procedure
1.
Check the Scope of Delivery according to the Bill of Delivery
2.
Read this manual completely
3.
Do the initial operation for every single tag
4.
Mount the tags
5.
An additional performance check of the tags and a system test can now be done
2.3
Scope of this Document
This document is the user’s manual of the model i-B2X W tag.
This document is intended only for mechanical installation rsp. everyday use.
Both mounting techniques described in this document are suitable for ATEX conformity.
2.4
Safety Instructions
Operational Safety
The device described in this manual is for exclusive operation by trained employees.
The correct and safe use of these systems assumes that operating and service personnel follow the safety
measures described in the manual alongside the generally acceptable safety procedures.
If there is a possibility that safe operation cannot be guaranteed the system must be switched off and secured
against accidental use. Then the service unit responsible must be informed.
Do not open the housing
There is no need to open the housing. There are no user serviceable parts inside. Set-up and configuration
during initial operation is done wireless with the built-in air interface.
2.5
Responsibility
IDENTEC SOLUTIONS is not responsible for any errors occurring in this document.
2.6
Associated Documents
•
ID.0669.EN_i-B2X W — Wristband tag Datasheet
