Section 1 :Introduction
2019_200000XXXX-V0
IDEMIA
D
OCUMENT
-
R
EPRODUCTION AND
D
ISCLOSURE
P
ROHIBITED
17
December 2018
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter by Industry Canada.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
Others recommendations
The MorphoAccess® VP MD incorporates a capacitive sensor for contactless finger
presence detection.
In the presence of electromagnetic disturbances, this function can be activated
inadvertently. This behavior remains normal (the electromagnetic field modifies the
capacity of the sensor) and has no impact for the user (the access control remains
functional) outside the light signal. To avoid the light signal, Idemia recommends the
use of an EMI filter on the power lines and recommends, as far as possible, to install
the MorphoAccess® VP MD at a sufficient distance from the antennas of potential RF
transmitters.
Potential safety conditions notice
If you notice any of the following conditions (or if you have other safety concerns), do
not use the product: crackling, hissing, or popping sound, or a strong odor or smoke
coming from the product. It is normal for these conditions to appear when an internal
electronic component fails in a safe and controlled manner. However, these conditions
may also indicate a potential safety issue. Do not assume it is a safe failure. Turn off
the product, disconnect it from its power source, and contact technical support for
assistance.
Disposal of waste equipment by users
This symbol means do not dispose of your product with your other household waste.
Instead, you should protect human health and the environment by handing over your
waste equipment to a designated collection point for the recycling of waste electrical
and electronic equipment.
