iDect X1, User Manual

Page: 22 / 30

Base unit settings
The BASE SETTING menu lets you customise your base
unit to suit your preferences. Some of the functions in
this menu have been covered earlier in this User Guide.
To go into
the Base
Setting
menu 1 Press the MENU button
è
The display shows PHONEBOOK
2 Press the
â
button THREE times
è
The display shows SETTING
3 Press the PHONE/OK button then the
â
button
è
The display shows BASE SETTING
4 Press the PHONE/OK button
If you’ve set a new PIN for the base unit (page
34), the display will show
ENTER BASE PIN *
and you’ll need to key it in. If you’ve left the PIN
at its default of 0000, you won’t be asked for it at
this point.
5 Press the
â
button to go to the option you
want, then the PHONE/OK button to select
it
All instructions below follow from this step.
When you’ve finished:
◗
Press the HANG UP button to go back to
standby mode
You can also press the HANG UP button at any point to
cancel what you’re doing and go back one step.
When you’re keying in numbers, if you make a mistake,
press the
HANG UP button to delete digits.
36
Ringer volume
and melody These are set using the ACOUSTIC SETTING option. See
page 13 for details.
Time & day See page 10 for details.
Returning to
default
settings The default settings for the base unit are:
■
Ringer volume level — 3
■ Ringer melody —
3
■
Time and day — 00:00 SUN
■ Dialling mode —
TONE
■
Recall (flash) length —
100MS
■
Base unit PIN — 0000
■
Call timer — reset to zero
■
Call Barring — OFF
■ Emergency numbers —
999
and
112
To return all base unit settings to their defaults:
1 Select the DEFAULT SETTING option
è
The display shows CONFIRM DEFAULT
SETTING?
2 Press the PHONE/OK button to confirm, or
the HANG UP button to cancel
è
The display shows
DEFAULT SETTING DONE
Dialling type
and recall
signal The next option in the Base Setting menu is
LINE SET
TONE - 100MS . This is for setting the dialling type and
the recall (flash) signal length, and you probably won’t
ever need this option.
You should always leave the dialling type at its
default setting
— TONE . You should not need to
change the recall signal setting unless you’re having
problems using your iDECT X1 on a PBX. Refer to page
46 for more information.
Base unit settings
Help Line: 0845 345 9677
(Local Call rate)
37
E:\Binatone2005\iDECT_X1\iDECT_X1_UK_draft02a.vp
25 August 2005 16:47:48
Color profile: Generic CMYK printer profile
Composite Default screen