IDEC HR6S-S, Original Instructions Manual

Page: 48 / 97

Installation
48
HR9Z-B2202 8/2020
Prerequisites and Requirements
Inspecting the Device
Damaged products may cause electric shock or unintended equipment operation.
Verify the product type by means of the type code ( see page 19 ) and the data printed on the
device.
Control Cabinet/Enclosure
Install the device in a control cabinet or enclosure with degree of protection IP54 that is secured
by a keyed or tooled locking mechanism.
The ventilation of the control cabinet/enclosure must be sufficient to comply with the specified
ambient conditions for the device and the other components operated in the control
cabinet/enclosure.
Label on Extension Module Connector
The connector for connection of the extension module HR6S-EP is covered by a label. Do not
remove the label from the connector unless you want to connect the extension module HR6S-EP.
DANGER
ELECTRIC SHOCK OR UNINTENDED EQUIPMENT OPERATION

Do not use damaged products.

Keep foreign objects (such as chips, screws or wire clippings) from getting into the product.
Failure to follow these instructions will result in death or serious injury.
NOTICE
INOPERABLE EQUIPMENT
Do not remove the protective label from the extension connector unless you are immediately
attaching an extension module.
Failure to follow these instructions can result in equipment damage.