IDEAL SecuriTEST, User Manual, Page: 20 / 40

19
Digital MultiMeter Mode:
Use the MultiMeter mode to measure voltage, current
and resistance. In the resistance mode the continuity
beeper can be turned on to generate an audible tone
when the measured resistance is less than 80 ohms.
PTZ Controller Mode:
In this mode, the up, down, right, left movement for
PTZ cameras is controlled. Zoom and focus can also
be adjusted using the Tele/Wide and Far/Near buttons.
UTP Cable Test Mode:
UTP cables are tested for straight (direct), crossover,
opens, and shorts. The yellow UTP terminator must be
placed on the far end of the cable to make
measurements. Press the SET button to begin the
cable test.
The UTP test does not report the length of the cable.
View Information Mode:
In this mode, the basic information of SecuriTEST can
be seen (firmware version, battery level,
communications protocol and speed).
Main Setting Mode:
In this mode, the basic setup of SecuriTEST can be
changed (user’s name, auto power off time, beeper,
brightness, contrast, etc).
HELP
: HELP information relevant to the
current mode is displayed when
the key is pressed on for more
than 2 seconds.
This function gives a brief
explanation of the current
function.