IDEAL HYJD-25, Operator'S & Parts Manual, Page: 18 / 67

14
TILT-A-WAY
HYDRAULIC OPERATOR GENERAL ARRANGEMENT
HYJD-25, HYJD-25E, SSHYJD-25, & SSHYJD-25E
RGHY-3006
TILT-A-WAY
RECOMMENDED GENERAL MAINTENANCE
RGHY-3006
Check interior of pedestal for any accumulation of trash caused by blowing wind and
remove.
On regular basis the following maintenance steps should be preformed
(Monthly)
.
1. Check hydraulic fluid level with site gauge on oil reservoir. Level to be
approximately 2 ½ “ below the top of the pipe. If required, add Dextron #4
hydraulic fluid “same as automatic transmission fluid”. Check with cylinder
retracted.
2. Clean and lubricate spring tension screws with “general purpose grease” to
prevent rusting.
3. Lubricate with “general purpose grease such as a bearing grease” all pints
equipped with zerk fitting.
A. Barrier carriage pivot bearing.
B. Cylinder anchor pivot.
C. Cylinder rod end pivot bearing.
REF NO. DESCRIPTION
1
Control Pedestal Frame For covering. See Drawing RGHY-3005 Page 11
2
Barrier Unit See Drawing RGHY-3004 Page 20
3
Hydraulic Pump & Reservoir See Drawing RGHY-3015 Page 27 & Page 31
4
Electrical Control Enclosure See Drawing RGHY-E200 Page 7
5
Barrier Carriage See Drawing RGHY-3007 Page 17
6
Balance System Cable Guide
Assembly. See Drawing RGHY-3009 Page 21
7
Balance System Cable Guide
Assembly. See Drawing RGHY-3010 Page 22
8
Balance System Tension Cable See Drawing RGHY-3009 Page 21
9
Balance system Tension Spring See Drawing RGHY-3012 Page 25
10
Balance System Spring Tension
Adjusting Limit See Drawing RGHY-3011 Page 25
11
Balance System Spring Tension
Release
“Power Off Safety Switch”. See Drawing
RGHY-3013 Page 25
12
Hydraulic Actuating Cylinder See Drawing RGHY-3008 Page 19
13
Cylinder Control Actuating
System See Drawing RGHY-3008 Page 19