Supplied By www.heating spares.co Tel. 0161 620 6677
4
Systemiser SE -
User's
Electricity Supply
This appliance is intended to be connected to the supply via a
double-pole switch, having a 3mm contact separation in both poles,
serving only the boiler and system controls. Alternatively, a 3-pin
UNSWITCHED socket may be used. The fusing should be 3A.
IMPORTANT NOTES
•
THIS APPLIANCE MUST NOT BE OPERATED WITHOUT THE
CASING CORRECTLY FITTED.
•
If the boiler is installed in a compartment then the compartment
MUST NOT be used for storage purposes.
•
Clearances of 180mm above, 100mm below, 5mm at the sides
and 450mm at the front of the boiler casing must be allowed
for servicing.
•
If it is known or suspected that a fault exists on the boiler then
it MUST
NOT BE USED
until the fault has been corrected by a
registered installer.
Legend
A
Control door
B
Control panel
C
On/off switch
D
Central heating on/off switch
E
Central heating pressure gauge
Introduction
The
Systemiser SE
is a wall mounted, room sealed, super efficient
condensing system boiler, featuring full sequence automatic spark
ignition and fan assisted combustion.
Due to the very high efficiency of the boiler, condensate is produced
from the flue gases and this is drained to a suitable disposal point
through the plastic waste pipe at the left lower rear of the boiler. A
condensate 'plume' will also often be visible at the flue terminal.
Safety
Gas safety (Installation & Use) Regulations 1994,
amendments 1996 or rules in force.
In your own interest, and that of safety, it is the law that this boiler
must be installed by a registered installer, in accordance with all
national and local regulations.
It is essential that the instructions in this
booklet are strictly followed, for safe and
economical operation of the boiler.
BOILER CONTROLS
