background image

Supplied By www.heating spares.co  Tel. 0161 620 6677

5

Response 80 / 100 / 120 - 

User's

Check that the overheat thermostat has not tripped -
press button (H) to reset.

If these simple checks fail to solve the problem, or the
problem recurs, consult your service engineer.

B

Hot water but no heating

Check that the programmer and room thermostat (if fitted)
are both calling for heat.

If the boiler has been switched off 

completely

 for some

time the pump may have stuck (if hot water is in use this
should 

not

 happen as the pump runs for 5 seconds at the

end of each hot water draw-off). A sharp tap on the metal
body of the pump may free it.

If these simple checks fail to solve the problem, or the problem
recurs,  consult your service engineer.

C. Heating but no hot water

Check that 

cold

 water does flow out of the hot taps at a

minimum rate of 3.5 litres per minute (or 1 pint in 10
seconds or less).

If not, look for stop valves not fully open.

If these simple checks fail to solve the problem, or the problem
recurs,  consult your service engineer.

D.

Hot water temperature incorrect

If the supply of hot water from the appliance is incorrect
with the domestic hot water tap fully open then the
Response boiler includes a domestic hot water restrictor
handle for you to adjust the water flow rate to obtain the
temperature you require. The restrictor handle is located
beneath the boiler on the left.

BOILER CONTROLS

To shut down the boiler

Set the mains switch (C) to OFF.

When heating is again required, restore the switch to the ON
position.

WARNING.

If no frost protection is provided and frost is likely during a short
absence from home, leave the heating controls (or control (F) )
at a reduced temperature setting.

For longer periods, the entire system should be drained -
including the domestic water supply .

If the system includes a frost thermostat then, during cold
weather, the boiler should be turned OFF by selecting the OFF
programme at the time control.

The mains supply should be left switched ON.

If in doubt, ask your installer.

To relight the boiler

Repeat the procedure detailed in 'To light the boiler'.

Faults

A. No heating or hot water

Check that gas and electricity are available at the boiler and
that all switches are on.

Check that the system water pressure gauge (G) reads 

at

least 0.5 bar

.

Rotate the restrictor handle anti-clockwise
to increase temperature and clockwise to
decrease temperature as indicated on the
handle.

LEGEND

A

'Mains on' neon

B

'Burner on' neon

C

Mains switch

D

Heating switch

E

Programmer (optional)

F

Radiator temperature
control

G

System water pressure
gauge

H

Overheat thermostat reset

Note.

Small movements of the handle will only be necessary
to effect the water temperature change required.

If these simple checks fail to solve the problem, or the
problem recurs,  consult your service engineer.

Summary of Contents for Response 80









Reviews: