ideal Boilers
, P.O. Box 103, National Ave, Kingston Upon Hull, HU5 4JN. Tel.
01482 492251 Fax. 01482 448858. Registration No. London 322 137.
ideal Stelrad Group
pursues a policy of continuing improvement in the design and performance of its
products. The right is therefore reserved to vary specification without notice.
Ideal Consumer Helpline
Tel: 01482 498376
www.idealboilers.com
to shut down the Boiler
1. For short periods
Set the external controls to OFF. Wait 10 minutes and then
isolate the mains supply to the boiler.
2. For longer periods
Set the external controls to OFF. Wait 10 minutes and then
isolate the mains supply to the boiler. For longer periods the
entire system should be drained, including the domestic hot
water supply.
to relight the Boiler
Refill the system if it has been drained, taking care to ensure no
air is in the boiler or system.
Repeat the procedure detailed in 'To light the boiler'.
frost protection
The
xtra
boiler has built into its control system the facility
to protect the boiler only against freezing.
Note
.
This may not protect remote parts of the system, in which case
a separate frost protection should be fitted.
Boiler Overheat
Boiler overheating is detected by electrical sensors connected
to the boiler control module. If the boiler overheats it will shut
down and the display will show E18. Press the 'reset' button
(D) and the boiler will relight. If the fault recurs turn off the
boiler and consult a Gas Safe Registered Engineer or in IE a
competent person.
condensate drain
The condensate drain must not be modified or blocked.
Blockage of the condensate drain, caused by debris or freezing,
can cause automatic shutdown of the boiler or leakage from the
condensate trap mounted on the bottom of the boiler.
If freezing is suspected and the pipe run is accessible an attempt
may be made to free the obstruction by pouring hot water over
the exposed pipe and clearing any blockage from the end of the
pipe. If this fails to remedy the problem the assistance of a Gas
Safe Registered Engineer or in IE a competent person should be
sought.
escape of Gas
Should a gas leak or fault be suspected contact your local gas
supplier without delay.
Do NOT search for gas leaks with a naked flame.
cleaning
For normal cleaning simply dust with a dry cloth.
To remove stubborn marks and stains use a damp cloth and mild
detergent.
DO NOT use abrasive cleaning materials.
202863-8.indd 64
18/10/2010 08:46:17
