16
Classic
FF
-
Installation & Servicing
INSTALLATION
REAR FLUE OUTLET
1. Pull the flue through the wall mounting plate and
locate the 3 studs in the holes in the back panel.
2. Secure the flue to the boiler using the three M5 wing
nuts provided.
3. Pull the flue extension tube and engage onto the fan.
Locate and secure with the M4 screw attached to the
fan.
Note.
The sealing ring studs will locate in the back panel one
way only. This will ensure that the terminal grille is
correctly aligned.
18 MOUNTING THE BOILER
Note.
Have ready to hand the M8 screw,
washer and rectangular plate supplied in the
hardware pack. For downward routing of
pipes the M5 spacer (supplied in the
Downward Piping Kit) should now be fitted to
the back of the boiler.
1. Lift the boiler onto the wall mounting plate
hooks as shown.
Do not use the burner / controls for
lifting
2. Fit the M8 screw, washer and rectangular
plate to retain the boiler.
Note.
Before fully tightening the M8 screw, check
the boiler alignment, using a spirit level, and
adjust as necessary with the jacking screw.
19 CONNECTING THE FLUE TO THE BOILER
20 TERMINAL WALL PLATE
This plate allows neat concealment and full compression of
the rubber seal. Its use is not essential if the flue hole and
flue ducts have been accurately cut and the outside wall
face is flat.
1. Position the terminal wall plate over the terminal.
2. Mark and drill 4 fixing holes with an 7mm (
9/32
") masonry
drill.
3. Insert the 4 plastic plugs provided.
4. Secure the plate with 4 of the No.10 x 2" screws
provided.
Note.
If the terminal is less than 2m (6' 6") above ground
level, an approved terminal guard should be fitted. Refer to
the Contents List on Page 3.
