idatastart COM-IDS(RS)-BZ3-[CMBMXA0]-EN, Install Manual

Page: 18 / 28

Patent No. US 8,856,780 CA 2759622
>>
>>
01
ENGINE
START
STOP
STOP ACC ON START ON
02
03
>>
>>
04
05
ENGINE
START
STOP
STOP ACC ON START START
06
07
ENGINE
START
STOP
STOP ACC ON START STOP
08
MODULE PROGRAMMING PROCEDURE - PTS - 1 OF 1
One of the connectors of the CAN junction
connector controls the keyless authorization
system (Keyless Go). The following procedure
will allow the module to identify the required
CAN connector.
Have the CAN junction connector accessible.
Identify every CAN connector whose CanH
and CanL wires match the colors listed in the
WIRE CHART.
LED 1 is solid RED. Push start button to ON
position.
Wait, LED 1 will fl ash RED/GREEN.
Disconnect the fi rst connector of the CAN
junction connector whose CanH and CanL
wires match the colors listed in the WIRE
CHART. Wait 5 seconds.
If the parking lights fl ash, the required
connector is found. Connect it to the C1
connector as shown in the WIRING DIAGRAM
and go to step 5.
If the parking lights do NOT fl ash, the required
connector is NOT found. Reconnect it to the
CAN junction connector and repeat step 4 with
another connector.
Wait, LED 1 will turn solid GREEN then will
turn solid RED.
START vehicle for 15 seconds. LED 1 will turn
solid RED.
Wait, LED 1 will turn solid GREEN then will
turn OFF.
Push start button to OFF position.
Module Programming Procedure completed.
www.idatastart.com Automotive Data Solutions Inc. © 2022 COM-IDS(RS)-BZ3-[CMBMXA0]-EN
PAGE 18 OF 28
• 20220124
DOC.: #78844