XX-XX
PAGE X-X
ADS-AL(DL)-CH4 1-2
PAGE X-X
ADS-AL(DL)-CH4
90
inStaLLatiOn mOde SeLeCtiOn
1
Press and release
programming button
to select installation mode.
2
Press and hold
programming button
until LED turns solid GREEN
to register selection.
!
After registration, follow Factory Reset Procedure to
change installation mode and restart this procedure.
LED fl ashes (1X) once = DATA MODE
LED fl ashes (2X) twice = STANDARD HARDWIRE MODE
mOdULe PrOgramming PrOCedUre
1
Close driver door.
Re-open driver door to wake up
data bus.
6
Turn key to OFF position.
OFF
2
Insert key into ignition.
3
Turn key to ON position.
ON
5
Within 5 seconds, LED will fl ash
GREEN rapidly.
4
LED will turn solid RED.
10
Module Programming
Procedure completed.
8
Press UNLOCK on the OEM
remote.
If vehicle is not equipped with
OEM remote, press module
programming button.
UNLOCK
9
Wait, LED will turn solid GREEN
for 2 seconds.
7
Remove key.
Page 6 of 9
ADS-AL(DL)-CH4
20110519
install guide
guides Français disponibles au www.idatalink.com
www.idatalink.com/support
automotive data solutions inc. © 2011
ALL IN ONE
Chrysler/DoDge/Jeep
Doc. No.: ##5401##
