Copyright © 2010, International Technologies & Systems Corporation. All Rights Reserved
7 of 65
ID TECH EzWriter
Quick Start
This Quick Start section covers EzWriter installation and WorkShop software installation. A
simple example is given to introduce WorkShop & EzWriter operation. The example guides
an operator through the process of writing a few characters onto a magnetic stripe card and
then through the process of reading the card to see the written data.
Installing WorkShop Software
The WorkShop software runs on Microsoft Windows platform for EzWriter with an RS232 or
USB communication interface.
All the software is provided on a CD or is available on the ID TECH website in the form of a
downloadable ZIP file. The downloaded Zip file has internal files, which must be extracted
before using. Install WorkShop on a PC by Running the Setup file located on the CD or
located in the extracted ZIP files. Follow the directions and process in the installation
wizard. The result is a “IDT EzWriter WorkShop Vx.x” menu item added to the Programs
menu in the Windows START menu. A file folder is added to the Program Files folder on
the local hard drive. The new folder name is “IDT EzWriter Workshop”. This folder
contains the Workshop application and support files for Reading and Writing cards.
Installing EzWriter
EzWriter is used in an indoor environment. Locate the EzWriter where it is convenient to
operate and protected from dust and liquids. For right-handed persons, swiping a card is
most convenient from right to left. Position the EzWriter so the flared card entrance is on
the right. A 24VDC power adaptor is provided. The adaptor input voltage range is 100 to
240VAC and can be used in most countries. The line power plug may need to be adapted
to the power outlet connector. Remove the power adaptor from the packing box. Wait to
connect the power adaptor until all the other connections are made.
The communication type can be RS232 or USB-RS232. Proceed to the Communication
Interface section corresponding to the interface of your EzWriter unit.
Communication Interface
RS232
The EzWriter has a communication cable with a DB-9 connector that fits most computer
serial (RS232) COM port connectors. An adaptor (not supplied) can be used to adapt to a
DB-25 connector if necessary. See the Specifications, Interface Section for port settings.
Connect the DB-9 connector to the PC and insure it is fully seated. Connect the power
adaptor output to the power connector on the back of the DB-9 housing. Finally, connect
the power adaptor to the AC line power outlet. When power is applied, the LED on the
Reader/Writer is orange for a moment and then becomes green. If the LED does not light,
check the connections and the availability of power from the power outlet.