ID Photonics CoBrite DX1, User Manual, Page: 4 / 44

___________________________________________________________________
3
Co Brite
DX1
User’s Manual
1 General Information
1.1 Warning Laser Safety
The laser sources specified by this user guide are classified according to IEC 60825-
1 (2007) Laser Notice No. 50 dated 2007-June-24 and comply with CFR 1040.10
except deviations per Laser Notice No. 50, July 2001 Key Feature Number 4.
This device is a Class 1M laser product for use only under the recommended
operating conditions and ratings specified in this document. Use of controls or
adjustments or performance of procedures other than these specified in this product
datasheet may result in hazardous radiation exposure.
Do not view the laser output from this device directly with optical instruments (e.g.,
eye loupes, magnifiers, microscopes). Viewing the laser output with certain optical
instruments within a distance of 100mm may pose an eye hazard. The class 1M laser
product definition is based on all conditions defined in this section.
Please pay attention to the following laser safety warning: Under no circumstances
look into the end of an optical cable attached to the optical output when the device is
operational. The laser radiation can seriously damage your eyesight. Do not enable
the laser when there is no fiber attached to the optical output connector. The laser is
enabled by press ing the ’Laser on’ button in the operating software delivered with the
instrument. The laser is on when the red LED on the front panel of the instrument is
lit. The use of optical instruments with this product will increase eye hazard.
In doubt about laser safety requirements consult a trained laser safety instructor for
local safety requirements of this product.
1.2 Compliance Statement Electromagnetic Compatibility and device safety
Hereby, we confirm that the system has been demonstrated and audited for
compliance for the following directives.
INVISIBLE LASER RADIATION
DO NOT VIEW WITH
OPTICAL INSTRUMENTS
CLASS 1M LASER PRODUCT
(IEC 60825-1/2007)