___________________________________________________________________
Co
Brite
DX1
User Manual
12
3.1
Connection of Hardware
•
Connect optical fibers to the laser output ports or make sure that no laser
radiation can be uncontrollably emitted by the unit.
•
Connect the power supply of the unit using the supplied Power Cord and
switch on the unit using the switch located at the back of the unit (MX und DX4
only).
•
If operating a MX type unit (modular chassis), insert the supplied Laser lock
key into the lock located on the front plate and turn it. Press the “power on”
button located on the front panel to start the unit
•
Wait for at least 30seconds and proceed with Software installation as
described below.
3.2
Installation of Control Software
Connect the supplied installation medium
and start “
CoBrite_Installer
.exe”
located
in
“GUI_I
nstaller
”
directory if it is not automatically executed.
Note
: If installing updates of the GUI Software, do NOT select the
“CDM20802 driver” as it will
install multiple instances of the driver.
Follow the instructions shown on the screen. Once finished, an icon is installed on
your computer to start the GUI. Note that the software requires Microsoft .NET
framework R3.5 or higher. This is available won any Windows XP PC with Service
pack 2 or later.
Once the software is installed, connect to either to one of the available USB Ports or
the Ethernet Port. See section
“Interfaces”
for details. If the USB Port is connected
for the first time, it will now automatically install a required driver to operate the
instrument.
Please start the Control Software “Cobrite”
after
the installation of the required driver
is completed.
3.3
Troubleshooting
3.3.1
Instrument was not detected by the GUI
Please change to the directory “Driver” on the supplied installation medium and
execute the file “CDM20802.exe” which installs a driver.
Reconnect the USB connection to your computer. The instrument should now
correctly be detected.
Summary of Contents for CoBrite DX1
Page 1: ......