Icy Dock MB662U3-2S R1, User Manual

Page: 6 / 60

4
English
1. Insert two hard drives into the enclosure, plug in the USB 3.0 cable, connect the
power adapter to the enclosure, and then turn on the power. The RAID mode is
set default to JBOD.
2. Select the preferred RAID mode by using the RAID switch located on the back of
the enclosure.
3. Press the "Reset" button located on the back of the device for at least 3 seconds
until the front white LED indicator flashes then release. The white LED indicator
will become solid white once the RAID mode change has been completed.
4. Reformatting the hard drive(s): delete the old drive partition(s) (if applicable)
and recreate new drive partition(s).
The device is factory preset to JBOD mode (system will recognize the two drives as
two individual volumes). If you wish to only change the RAID mode, please skip step
1 and go directly to step 2. Verify the device is powered on while changing the RAID
mode.
5
Using the RAID Mode
Caution: Changing RAID settings permanently erase any erase data on the hard drive
and cannot be restored. If there are existing data on the hard drive, please
back up the data first then setup the RAID.
6
LED Status Indicators
LED Indicators
HDD(s) in Bay
Back Panel LED
Front Panel LEDs
No light
RAID Status
RAID Rebuilding
RAID Rebuild Completed No Light
HDD Access
HDD Fail
Empty Bay
Verifying or Confirmation
Flashing white LED
Flashing white LED
Flashing white LED
Solid red LED
Solid white LED