If you have any questions, please call 1-800-558-4435
ICWUSA.com, Inc.
ICWUSA.com, Inc.
SCANNER BRACKET INSTALLATION
SCANNER BRACKET INSTALLATION - 12/4/19
ATTACH BRACKET MOUNT TO KEYBOARD
Align mounting holes in
clamps with slot in keyboard.
Insert screws with Loctite
and tighten using provided
1/8” hex key.
Behind-the-keyboard scanner bracket SCHO8X1902
• Bracket bar length: 8”
• Scanner plates for Honeywell bracket plate
SCH08X1902
NOTICE: ICWUSA.COM, Inc. provides the appropriate hardware fasteners to
match the majority if not all standard monitors and devices. It is the responsibility
of the installer / integrator to ensure that the screws and fasteners have the
adequate thread engagement. The rule of thumb is that the thread depth is
greater than the diameter of the hole or 4 full turns of 360 degrees of thread
engagement. It is also the responsibility of the installer / integrator to ensure that
they do not damage the monitor or device by using a screw or fastener that is too
long for hole and therefore damaging the unit by inserting too far.
When cleaning your ICW mounting unit please follow the points below. Proper
cleaning of the mounting device will help assure proper function and extend the
life of the unit.
1. Any general cleaner is acceptable except degreasers are not recommended near
the bearing entrances.
2. Spray cleaner or water on a soft cloth or paper towel and then wipe down
the mounts.
3. Do not spray directly at the bearing seams (located at all swivel points) as this could
reduce the life of the bearings.
CLEANING OF THE ICW MOUNTING DEVICE
