Mounting
1.
Select where to mount the touchscreen. Keep the following guidelines in mind:
-
The standard height for mounting is
1.4m (4.6ft)
.
-
The touchscreen should be mounted on a wall with adequate air flow around and through it.
-
Ensure the unit is mounted a minimum of 1.1m (3.5ft) away from other wiring such as ACM power,
computer data wiring, telephone wiring and wiring to electric lock devices.
Use the technical diagram (see page 13) as a guide for correctly positioning the unit.
2.
Hold the rear case half against the wall and mark the mounting holes and cable entry area. The cable entry
area should align with a hole cut through the plaster wall-board. Cables are intended to be run inside the wall.
3.
Use appropriate screws (not supplied) to affix the case to the wall.
4.
Run the wiring. Leave about 20cm (8") of wire protruding through the center of the mounted half of the case
and connect the wiring to the touchscreen electronics as shown in the
section.
5.
Align the top of the front body onto the recessed hinge points at the top of the rear case, then press gently
until the bottom portion snaps into place.
PRT-TS50-TH | Protege 5" Touchscreen | Installation Manual
6