Modular Power Series
855-340-004_Rev2.0_Instruction Manual
Page
4
of 81
•
Configure the software settings.
•
Energize the loads and battery connections.
2.2 Unpacking and Inspection
Perform a physical check of the unit as it is being taken out of the box to
ensure it has not been damaged during shipping. Check that the system
configuration matches the version ordered, and that the accessories under
the package contents section were shipped with the unit.
NOTE: In case of shipping damage, the freight carrier should be notified
immediately.
2.3 Package Contents
•
Power shelf
•
Instruction Manual (in bag)
•
Removable 3-pin AC input wire clamp connector plug (in bag)
•
Removable 7-pin alarm and temperature sensor wire clamp connector
(in bag)
•
Removable 3-pin form-C alarm relay connector (in bag)
•
Plastic U-shaped cover with four 6-32 x 1/4-inch screws for output bus
bars (in bag)
•
Two rack-mounting ears (installed)
•
Two bolt/washer/nut sets for connections to the output bus bars (in
bag)
•
Two bolt/washer/nut sets for connections to the BMM bus bars (in bag)
included when a BMM is installed in the shelf
•
Remote battery temperature sensor (ICT-TMP) included when a BMM
is installed in the shelf
2.3.1 Tools and Parts Needed
•
Two 7/16-inch wrenches
•
Wire stripper
•
Four #10-32 Phillips screws (length to be decided by installer) to
connect rack ears to rack
•
#2 Phillips screwdriver for the rack ear connections and output bus bar
cover
•
#1 Phillips screwdriver for the AC input connector
•
5/32-inch flathead screwdriver for the AC input wire connection
•
3/32-inch flathead screwdriver for the form-C alarm relay connector,
alarm and sensor wire connection
