BASIC SETUP
This page allows you to configure the basic settings of the panel. To save any changes to the basic
settings, click on
Save Settings
at the bottom of this page.
PANEL INFO
Site Name:
Allows you to assign a custom name to the panel.
Model:
Displays the model number of the panel.
OUTPUTS
Label:
Allows you to assign a custom name to each individual output. The output names are displayed
on the
Status & Control
page, as well as on the LCD screen.
Load-Shedding:
Allows you to turn on load-shedding for each individual output. Load-shedding
automatically disables DC power to the output when the panel’s system under-voltage alarm is
triggered. The under-voltage threshold is set on the
Alarm Setup
page.
The panel must remain in an under-voltage condition for at least 30 seconds before the output will be
disabled. This is to prevent the outputs from being disabled prematurely during a power surge.
Load-Shedding Auto Recovery:
If this box is checked, outputs that have load-shedding turned on will
automatically be enabled after panel’s system under-voltage alarm is cleared. The system under-
voltage alarm must remain cleared for at least 60 seconds before the outputs will be enabled. If this box
is unchecked, outputs will need to be manually re-enabled after load-shedding is triggered.
Send Load-Shedding E-mail:
If this box is checked, an e-mail alarm notification will be sent when
outputs are automatically enabled or disabled by the load-shedding setting. The e-mail settings on the
Network Setup
page must be configured correctly before e-mail notifications can be sent.
Power Cycle:
Allows you to turn on power-cycling for each individual output. When Power-Cycling is
enabled for an output, the output will automatically be re-enabled after a selectable period of time after
it is disabled from the
Status & Control
page. Power-Cycling is useful for remotely resetting power to
hardware that is needed for network connectivity to the panel.
The
Sequence / Cycle Delay
field controls the period of time that the output remains disabled before it
is re-enabled. The Power Cycle setting will have no effect if no time delay is entered in the
Sequence /
Cycle Delay
field.
If multiple outputs with Power-Cycling enabled are disabled from the
Status & Control
page at the
same time, they will be re-enabled in sequence.
10
Summary of Contents for ICT180-12IRC
Page 2: ......