PUSH MODE
WIRING BUTTON 2AMDI511VPVRDBS - FIGURE N. 4
In order to activate this mode of control/operation it is necessary to remove any control signals from the D + and D-
inputs and connect between the DALI/P1 and DALI/P2 inputs, a signal in direct or alternating voltage
(DC voltage range:10÷265V, AC 12÷265Vac 50÷65Hz) interrupted by a normally open button (N.O.).
No polarization is needed for the input signal.
The maximum current absorbed by the PUSH interface is about 2mA.
The dimmer saves the output position in order to restore the set level in case of power failure (preset).
PUSH interface operation
Single Click (rapid press (<1sec))
- Turns on or off the output (ON/OFF).
Double Click (rapid press (<1sec))
- Sets maximum brightness (output= 100%)
Long Press (long press (>1sec))
- If the dimmer is in OFF position, it sets the output to the minimum value (default= 1%)
- If the dimmer is in ON position, the long press enables the output dimming (up/down).
8
IOTLIGHT - User Manual 2AMDI511VPVRDBS
