© 2022 ICS, Oregon Tool Inc. Specifications are subject to change without notice. REV071918~ F/N 74595
814PRO OPERATOR’S MANUAL
6
SAFETY
CAUTION
THE FOLLOWING SYMBOL APPLIES TO ALL ITEMS LISTED ON THIS PAGE
A potentially hazardous situation exists which, if not avoided, may
result in minor or moderate injury or property damage.
• Always turn the saw OFF when performing maintenance on the saw including diamond
chain tensioning.
• Never use equipment that is not functioning properly. Have the saw repaired by qualified
service personnel.
• Insufficent water supply may result in excessive wear to the chain, which can lead to loss
of strength and chain breakage. Minimum water pressure is 20 psi (1.5 bar).
• Never start the saw unless the guide bar, diamond chain and side cover are properly
installed.
GENERAL SAFETY PRECAUTIONS
•
Always wear protective clothing, including hard hat, eye protection, hearing protection, and
gloves.
•
Avoid loose fitting clothing.
•
Perform safety checks before starting each day.
•
Always operate tool with solid footing and with both hands on cut-off saw.
•
Remove or control slurry to prevent slippery conditions while cutting.
•
Be sure there are no obstructions (plumbing, electrical conduit, air ducts) and no unnecessary
people present.
•
Set up a well-marked safety zone with a roped boundary and clear signs.
•
Provide adequate ventilation when working in an enclosed area. Breathing exhaust gases is
dangerous.
•
To avoid electrocution, check for live electrical wiring near cutting area.