background image

WWW.ICS-CTRL.COM

  

USER MANUAL FOR HARDWARE REV 1.0  

 

06-JUN-2019      

PAGE 2 

2.

 

CONTENTS 

TABLE OF CONTENTS 

1. 

Welcome ......................................................................................................................................... 1 

2. 

Contents ......................................................................................................................................... 2 

3. 

Hardware Introduction .................................................................................................................... 3 

3.1 

Duplex Port Configurable Features .............................................................................................. 4 

3.2 

Duplex Channel ........................................................................................................................... 4 

3.2.1 

Input Audio Adjust ................................................................................................................... 5 

3.2.2 

Flat audio select ....................................................................................................................... 6 

3.2.3 

Output amplifier gain .............................................................................................................. 6 

3.2.4 

CTCSS Active High/Low ........................................................................................................... 7 

3.2.5 

Port Connector & Pin 1 ............................................................................................................ 7 

3.2.6 

Output Audio Adjust ................................................................................................................ 8 

3.3 

Built-in Audio CODEC .................................................................................................................. 8 

3.4 

Analog to Digital Converter ......................................................................................................... 9 

3.5 

GPIO Expansion ........................................................................................................................... 9 

Getting Started with svxlink .......................................................................................................... 10 

4.1 

Hardware Pin numbers (SVXlink based) .................................................................................... 10 

4.2 

Advanced Configurations .......................................................................................................... 10 

Schematics .................................................................................................................................... 10 

 

 

 

 

Summary of Contents for PI-REPEATER-1X











Reviews: