F/N 521599 Oct 07
© 2007 ICS, Blount Inc.
P95 OPERATOR’S MANUAL
17
CONTROLLER / FAULT CODES
FLASH
CODE
FAULT
ENGINE
SHUTDOWN
CORRECTIVE ACTION
1
Unit not calibrated
YES
Have engine serviced by an Authorized ICS Dealer.
2
Engine speed
excessive
YES
Have engine serviced by an Authorized ICS Dealer.
3
Engine speed unusually
low
YES
Have engine serviced by an Authorized ICS Dealer.
4
Engine shutdown due
to engine protection
input
YES
Have engine serviced by an Authorized ICS Dealer.
5
Factory settings lost
YES
Have engine serviced by an Authorized ICS Dealer.
6
External pot out-of-
range
NO
Have engine serviced by an Authorized ICS Dealer.
7
Accelerator position/
idle switch conflict
NO
Have engine serviced by an Authorized ICS Dealer.
8
Controller unit failed
YES
Have engine serviced by an Authorized ICS Dealer.
9
Limiting excessive
actuator current
NO
Have engine serviced by an Authorized ICS Dealer.
10
Engine speed input
signal missing
NO
Check speed sensor wiring.
Check starter motor.
11
Auto crank unable to
start engine
NO
Check fuel.
12
Auxillary output is
shorted
NO
Check the lamp or relay hooked to the output. If fault is
still present, have engine serviced by and ICS Authorized
Deale.r
13
Auxillary output #2 is
shorted
NO
Check the lamp or relay hooked to the output. If fault is
still present, have engine serviced by and ICS Authorized
Dealer.
14
Actuator disconnected
or open circuit
NO
Check actuator wiring and actuatro resistance.
Resistance should be less than 10 ohms.
