P110 User Manual ◄ 15
FAULT CODES
Flash
Code
Fault
Engine
Shutdown
Corrective Action
1
Unit not calibrated
Yes
Have engine serviced by an Authorized Service Center.
2
Engine speed excessive
Yes
Have engine serviced by an Authorized Service Center.
3
Engine speed unusually low
Yes
Have engine serviced by an Authorized Service Center.
4
Engine shutdown due to
engine protection input
Yes
Have engine serviced by an Authorized Service Center.
5
Factory settings lost
Yes
Have engine serviced by an Authorized Service Center.
6
External pot out-of-range
No
Have engine serviced by an Authorized Service Center.
7
Accelerator position/idle
switch conflict
No
Have engine serviced by an Authorized Service Center.
8
Controller unit failed
Yes
Have engine serviced by an Authorized Service Center.
9
Limiting excessive actuator
current
No
Have engine serviced by an Authorized Service Center.
10
Engine speed input signal
missing
No
(Active only in Auto crank mode). Check speed sensor
wiring. Check starter motor.
11
Auto crank unable to start
engine
No
Check fuel.
12
Auxiliary output is shorted
No
Check the lamp or relay hooked to the output. If fault
is still present, have engine serviced by an authorized
Service Center.
13
Auxiliary output #2 is shorted No
Check the lamp or relay hooked to the output. If fault
is still present, have engine serviced by an authorized
Service Center.
14
Actuator disconnected or
open circuit
No
Check actuator wiring and actuator resistance.
Resistance should be less than 10 ohms.
Summary of Contents for P110
Page 2: ...2 P110 User Manual NOTES...
Page 25: ......