Fig. 2 — Remove filter cover screws (2), install
rear mounting bracket, reinstall the cover screws
and tighten securely.
Fig. 3 — Installation of Front Mount Bracket.
Remove saw’s flat surface of bracket mounts to
the saw, tapered edge points towards rear saw,
tighten securely using M5 screws (2, included).
Fig. 1 — 14" Gas Dust Director Components.
14" Gas
Dust Director
BLADE CAPACITY: 12" & 14"
A
Dust Director
®
for Your
Stihl Cut-Off Saw
INSTALLATION INSTRUCTIONS
•
DUSTLESS
CUTTING
•
VACUUM
INFORMATION
The 14" Gas Dust Director is shipped as follows (Fig 1):
• 14" Dust Director / Legs Assembly
• Front & Rear Mounting Bracket
• (2) M5 x .8 x 2 hex cap screws (for front bracket)
• (4) 1/4-20 x 1" hex cap screws w/ flat washers (secures the Dust Director
to the Mounting Brackets.
To Install the 14" Gas Dust Director to a Stihl Saw,
proceed as follows:
INSTALLATION OF REAR MOUNTING BRACKET (Fig 2).
• Remove the bottom two (2) hex screws from the saw’s filter cover
using a 3/16" allen wrench
• Align the Rear Mounting Bracket into the holes of the filter cover
(vertical leg of the Mounting Bracket towards the saw.)
• As you hold the Rear Mounting Bracket in place, insert the (2)
previously removed hex screws through the holes of the Rear
Mounting Bracket and tighten securely.
Installation of Front Mounting Bracket (Fig 3)
• Remove the saw’s two front rubber feet (2)
• With the flat side of the Front Mounting Bracket towards the saw
and its tapered edge points towards the rear of the saw, align the
bracket’s two outside threaded holes with the threaded holes of the
rubber feet (2).
• Using the provided M5 hex cap screws (2) tighten the Front
Mounting Bracket securely into the saw’s housing using a 5/32" or
M4 allen wrench.
412 . 824 . 6933
Industrial Contractors Supplies
www.DustDirector.com
