DIO48S/AT-P Manual
Page 4-2
Manual 00650-526-1
To set desired board address , refer to the illustrated Board Address setup program on the CD
provided with the card. Type the desired address in hexadecimal code and the graphic display
shows you how to set the Address Setup switches. These switches are marked A4-A9 and form a
binary representation of the address in negative-true logic. (assign '0' to all Address Setup switches
turned ON, and assign '1' to all Address Setup switches turned OFF.)
Switch Identification
A9
A8
A7
A6
A5
A4
Address Line Controlled
A9
A8
A7
A6
A5
A4
The following example illustrates switch selection corresponding to hex 2D0 (or binary 10 1101
xxxx). The "xxxx" represents address lines A3, A2, A1, and A0 used on the Card to select
individual registers at the PPIs. See Chapter 6, Programming.
Hex Representation
2
D
Conversion Multipliers
2
1
8
4
2
1
Binary Representation
1
0
1
1
0
1
Setup
OFF
ON
OFF
OFF
ON
OFF
Switch ID
A9
A8
A7
A6
A5
A4
Caution
Carefully review the address selection reference table on the previous page before selecting the
card address. If the addresses of two circuits overlap you will experience unpredictable computer
behavior.
Summary of Contents for DIO48S/AT-P Series
