Auto Sentry® Petro - Installation Guide
17
Molded Plastic Installation
NOTE:
If there is no sidewalk, a 6” metal riser is required to raise the Auto Sentry® Petro to
optimal ergonomic height. (Figure 15 demonstrates the 6” riser.)
1.
Lift up the base of the Auto Sentry Petro and place over the U-bolts.
Figure 8. (6) holes in metal base line up with plastic
There are two small Roto Molded gray plastic pieces #1 and #2 that fit together to cover the base
of the metal pedestal.
Figure 9. Base Roto Molded Plastic pieces
2.
Place roto-mold #1 on the front of the base and place roto-molded plastic #2 on rear of the
base.
3.
Line up the holes in the roto molded plastic cover pieces with the holes in the Metal base.
4.
Insert (2) 1/4” 20 x 1- 1/2” cap screws with 1/4” flat washers.
(Bag A / Bag H)
5.
Use a 3/16” hex key tool to tighten the screws snuggly and attach roto mold #1 and #2.
See Figure 9.
NOTE:
DO NOT OVER TIGHTEN. Two pound-foot torque is recommended. Over torquing could
cause shearing or cracking.