© 2014 ICS, Blount International Inc. Specifications are subject to change without notice. REV021414 F/N 566100
890 SERIES OPERATOR’S MANUAL
6
SAFETY
CAUTION
THE FOLLOWING SYMBOL APPLIES TO ALL ITEMS LISTED ON THIS PAGE
A potentially hazardous situation exists which, if not avoided,
may result in minor or moderate injury or property damage.
• Always turn the saw OFF when performing maintenance on the saw including chain
tensioning.
• Never use equipment that is not functioning properly.
• Have the saw repaired by qualified service personnel.
• Insufficient water supply may result in excessive wear to the Diamond Chain, which can
lead to loss of strength and Diamond Chain breakage. Minimum water pressure is 20 psi
(1.5 bar).
• SealPro
®
diamond chains require a minimum water pressure of 20 psi (1.5 bar).
Insufficient water supply may result in excessive wear to the chain, which can lead to loss
of strength and chain breakage, and/or damage to the guidebar nose sprocket.
• Never start the saw unless the guidebar, Diamond Chain and
side cover are properly installed.
GENERAL SAFETY PRECAUTIONS
• Always wear protective clothing, including hard hat, eye protection, hearing protection, and
gloves.
• Avoid loose fitting clothing.
• Perform safety checks before starting each day.
• Always operate tool with solid footing and with both hands on saw.
• Remove or control slurry to prevent slippery conditions while cutting.
• Be sure there are no obstructions (plumbing, electrical conduit, air ducts, etc.) and no
unnecessary people present.
• Set up a well-marked safety zone with a roped boundary and clear signs.
• Provide adequate ventilation when working in an enclosed area.
• To avoid electrocution, check for live electrical wiring near cutting area.
