814 OPERATOR’S MANUAL
11
OPERATION
SYSTEM CLEAN-UP
1. Run saw, with water on, for 15 seconds out of cut to flush slurry and debris from chain, bar and drive
sprocket.
2. Wash concrete slurry from saw assembly. Flush out valve handle with high water pressure, spraying
water into all three openings.
3. Remove bar and chain. Flush out chain tensioner assembly location with high water pressure and
lube with grease.
4. Clean all hydraulic flush-face fittings on saw and power pack.
5. When done cleaning saw, spray entire saw body, chain, bar, drive sprocket, and hydraulic flush-face
fittings with a light weight penetrating oil. This will minimize rust and reduce slurry build up on saw
assembly.
