701-A SERIES OPERATOR’S MANUAL
© 2015 ICS, Blount International Inc. Specifications are subject to change without notice. REV02292016 F/N 573498
7
TECHNICAL SPECIFICATIONS
Weight without bar and chain
29 lbs (13 kg)
Length
20 in (58.5 cm)
Height
10.5 in (26.5 cm)
Width
12 in (30.5cm)
Air Motor Power
6.5 Hp (5 Kw)
Air Supply Requirements (maximum)
90psi (6 bar)
124 cfm (3.5 m
3
/min)
Motor lubrication requirements
Resin and acid-free
SAE 5 W to SAE 10 W oil
Water Pressure Requirements
Minimum: 20 psi (1.4 bar)
Water Flow Requirements
1 gpm (4 lpm) minimum
Operating Speed
5,700 rpm (average free running)
4,900 sfm (average free running chain)
Vibration a
hv, eq
Concrete Cutting
(2)
Front handle: 5.09 m/s
2
(K=0.2 m/s
2
)
Rear handle: 5.07 m/s
2
(K=0.2 m/s
2
)
Vibration a
hv, eq
PowerGrit Cutting
(2)
Front handle: 4.58 m/s
2
(K=0.2 m/s
2
)
Rear handle: 4.43 m/s
2
(K=0.2 m/s
2
)
Guaranteed Sound Power Level L
wa
(1)
113 dB(A); (K
wa
=0.5 dB(A))
• When operating a compressor with pressure greater than 90 psi (6 bar) it is
recommended to use a “service unit with pressure regulator” in the line to prevent over
speeding the saw.
•Always use an in-line oiler(ICS p/n 575013 or 575130) or air pac ICS p/n 575013 to
provide continuous lubrication to the air motor. This will increase the life of the saw
and reduce down time.
(1) Measured in accordance with ANSI S12.51-2012/ISO3741:2010
(2) Measured in accordance with ISO5349-1:2001 and ISO22867:2011
