© 2016 ICS, Blount International Inc. Specifi cations are subject to change without notice. REV02292016 F/N 573498
701-A SERIES OPERATOR’S MANUAL
4
THE FOLLOWING WARNING SYMBOL APPLIES TO ALL THE ITEMS LISTED
ON THIS PAGE
Note: Chain breakage can result in high-speed ejection of parts, which
can result in death or serious personal injury to operators or bystanders.
The items listed immediately below are critical to minimizing the risk of
chain breakage and injury.
•
DO NOT operate the saw with damaged, modifi ed or missing
components shown below.
• Side cover
• Mud fl ap
• Rear hand guard
• Mud fl ap bracket (chain catcher)
• Trigger interlock
•
DO NOT exceed 90 psi (6 bar) and 124 cfm (3.5 m
3
/min) operating
pressure and volume.
•
DO NOT insert the diamond chain saw into a slot narrower than the chain
segments.
Rapid pushback might occur.
NOTE: Most ICS diamond chain segments are .225 inches (5.72 mm) wide.
•
NEVER run a diamond chain saw upside-down.
Concrete debris can fl y back into the operator’s face.
•
NEVER cut ductile iron pipe with concrete chain.
Segment loss or chain breakage may occur.
•
NEVER operate the ICS saw with a saw chain or saw bar designed to cut
wood.
Using wood cutting saw chain on the ICS saw could result in severe
injuries to operator and bystanders! Use ONLY the cutting attachments
specifi ed in this manual on this saw.
SAFETY
WARNING
Indicates a hazard with a medium level of risk
which, if not avoided, could result in death or
serious injury.
