ICS Schneider Messtechnik WIKA EGS80, Operating Instructions Manual

Page: 13 / 40

70101419
2018-12
11
Trip Amplifier EGS80X002001
Display Modes and Fault Messages
5 Display Modes and Fault Messages
In normal operation, the current measured value is indicated in the selected unit.
For information on selecting the unit, see section 6.2.
If the Alarm freeze (see section 6.4.3) is triggered but the device continues operating normally,
a corresponding message appears in the second line of the display.
If a fault occurs, one of the following messages is displayed until the fault is rectified
(when parameterized):
•
Err Mem for device fault,
• Err LB for lead breakage,
• Err SC for short circuit
For the selection of fault messages see section 6.3.1.
If switching the device on/off and checking the cables does not rectify the fault, please contact
Fuchs or the field device manufacturer.
The relays de-energizes when a fault occurs.
For information on the behaviour of the current output in the event of fault, see section 6.5.2.
The display of the device is updated at regular intervals. This can causes a short
flickering of the display. This flickering isn't a defect of the display.
Note