Chapter 2: WinBIOS Setup
Manual Number: 41209-103-1
Page 2-11
You can enter a password by:
Typing the password on the keyboard or Selecting each letter via the mouse.
When you select Supervisor or User, AMIBIOS prompts for a password. You must set the Supervi-
sor password before you can set the User password. Enter a 1 6 character password. The pass-
word does not appear on the screen when typed. Make sure you write it down. If you forget it, you
must drain CMOS RAM and reconfigure the system.
Changing a Password
Select the appropriate password icon (Supervisor or User) from the Security section of the WINBIOS
Setup main menu. Enter the password and press <Enter>. The screen does not display the charac-
ters entered. After the new password is entered, retype the new password as prompted and press
<Enter>.
If the password confirmation is incorrect, an error message appears. If the new password is entered
without error, press <Esc> to return to the WINBIOS Main Menu. The password is stored in CMOS
RAM after WINBIOS completes. The next time the system boots, you are prompted for the pass-
word if the password function is present and is
Enabled
.
Remember the Password
Keep a record of the new password when the password is changed. If you forget the password, you
need to reset the CMOS memory (refer to JP 9 on jumper settings - chapter 1)
Anti-Virus
When this icon is selected from the Security section of the WINBIOS Setup main menu, AMIBIOS
issues a warning when any program (or virus) issues a Disk Format command or attempts to write
to the boot sector of the hard disk drive. The settings are
Enabled
or
Disabled.
If
Enabled
, the
following appears when a write is attempted to the boot sector. You may have to type
N
several
times to prevent the boot sector write.
Boot Sector Write!!!
Possible VIRUS: Continue (Y/N)? _
The following appears after any attempt to format any cylinder, head, or sector of any hard disk
drive via the BIOS INT 13 Hard Disk Drive Service:
Format!!!
Possible VIRUS: Continue (Y/N)? _
Summary of Contents for 486MBS Series
