2A. INSTALLATION STEPS
MARGIN
GUIDES
Stay within the yellow
box. Do not let text go
beyond, instead move
to the next column or
start a new page.
3
|
www.icrealtime.com
Figure 2-1
Step 1
Use the supplied position map and adhere it to the mounting
surface. Drill the appropriate pilot holes for the mounting screws and
cable exit if the cable will go through the mounting surface. See
Figure 2-1.
Step 3
Tighten down the mounting screws. For mounting surface cable
exit, see Figure 2-3.
Step 4
For side cable exit, see Figure 2-4.
Figure 2-4
Figure 2-2
Figure 2-3
Step 2
Install the mounting screws through the mounting surface to
the mounting plate. Route the cabling as needed through the
mounting surface or the side exit notch of the camera base. See
Figure 2-2.
