LRA-900-E (Ethernet to LoRa Radio Modem) User Manual
Version 1.0.1
Page
：
26
Copyright © 2018 ICP DAS Co., Ltd. All Rights Reserved E-mail: [email protected]
The following is an overview of the parameters contained in the IP Address Settings section:
Item
Description
IP Address
Address Type
Static IP:
If no DHCP server is installed on the network, the network
settings can be configured manually. Refer to
for more details.
DHCP:
The Dynamic Host Configuration Protocol (DHCP) is a
network application protocol that automatically assigns an IP address
Section 4.4.1.2 Dynamic Configuration
for
more details.
Static IP Address
Each LRA-900-E connected to the network must have its own unique
IP address. This parameter is used to assign a specific IP address.
Subnet Mask
This parameter is used to assign the subnet mask for the LRA-900-E
device. The subnet mask indicates which portion of the IP address is
used to identify the local network or subnet.
Default Gateway
This parameter is used to assign the subnet mask for the LRA-900-E
device. The subnet mask indicates which portion of the IP address is
used to identify the local network or subnet.
MAC Address
This parameter is used to set a user-defined MAC address, which
must be in the format FF-FF-FF-FF-FF-FF.
Virtual COM
TCP Command Port
This parameter is used to configure the TCP Command Port to a
custom value depending on your requirement. Note that if the TCP
Command Port configuration setting is completed, the TCP port of RF
port will be change, as follows:
RF Port (port1) = TCP Command Port + 1
The default TCP Command Port is 10000, Thus, the RF port (port1) is
10001.
Command Port
Timeout
(Socket Watchdog)
If the command port does not receive any data from the TCP/IP
socket for a certain period, the LRA-900-E can disconnect the socket.
Settings range value: 1 ~ 65535 (seconds);
Default value: 180 (seconds); Disabled: 0;
Update Settings
Click this button to save the revised settings to the LRA-900-E.
