32
4.7 Peripheral Setup
This setup is working mostly on Multi-I/O Chip (W83977). The
options are used to change the Chipset‘ s registers. Please
carefully change any default setting to meet your application
need perfectly. The only special concern is Onboard Serial Port
2. If you want to use the IrDA port, you have to configure the
SIR or ASKIR model in the BIOS’ s Peripheral Setup’ s COM2;
the RS-232 COM2 will be disabled.
Onboard FDC >
to enable the FDC on your board. If you set it
Auto, the BIOS will decide if the FDC should be enabled,
automatically).
Onboard Serial Port A (/B) >
to specify the I/O port address of
the serial port 1(/2). If you set it Auto, the BIOS will decide the
correct I/O port address, automatically.
Serial Port B Mode >
to specify the mode of serial port 2.
IR Duplex Mode >
to specify the mode of IR device that is
connected to the IR port.
IrDA Protocol >
to specify the function mode if an IrDA mode
is selected.
Onboard Parallel Port >
to specify the I/O port address of the
parallel port.
Parallel Port Mode >
to specify the mode of parallel port. The
options are:
Normal
(normal parallel port mode),
