Technical support:
5
Wiring the DI and DO for Self-test
1)
Verify that Jumpers
JP1 and JP2
on the PISO/PEX-P32C32 Series
Card are set to the
“External Power (default)”
position.
Refer to
Chapter 2
“Jumper Settings” above (P2).
2)
Connect the DN-37 to CON1 on the PISO/PEX-P32C32 Series Card
using the CA-3710 cable.
3) Connect the
DI <0-15>
(Pin2 - Pin17)
with DO <0-15>
(Pin21
– Pin36).
i.e., DI0(Pin2) with DO0(Pin21)
…DI15(Pin17) with DO15(Pin36).
The External Power Wiring for PEX-P32C32/PISO-P32C32U:
4) Connect the
External Power 9V ~ +24 V
to
COM1A
(Pin18)
and
Ext.PWR0
(Pin37), see Figure 1-1.
5) Connect the
External Power Supply GND
to
COM1B
(Pin19)
and
Ext.GND0
(Pin1/Pin20), see Figure 1-1.
NOTE:
The PEX-P32C32/PISO-P32C32U suggests input voltage range +9 to
+24 V (Logic high). (Higher voltage over the limitation will cause the hardware
damage.)
The External Power Wiring for PISO-P32C32U-5V:
4) Connect the
External Power 5V ~ +12 V
to
COM1A
(Pin18)
and
Ext.PWR0
(Pin37), see Figure 1-2.
5) Connect the
External Power Supply GND
to
COM1B
(Pin19)
and
Ext.GND0
(Pin1/Pin20), see Figure 1-2.
NOTE:
The PISO-P32C32U-5V suggests input voltage range +5 to +12V (Logic
high). (Higher voltage over the limitation will cause the hardware damage.)
