PDS-220Fx Series User Manual (V1.2, Apr. 2015)
74
7.3.22
CONFIG
Description:
This command is used to clear the settings in the EEPROM.
Effect:
Immediate
※
When “Config=RESET” is used, the Password, Alias and IPFILTER settings will also be
cleared, but the IP/MASK/GATEWAY addresses will not.
※
The SystemTimeout setting is also cleared to 0 by the "config=RESET" command, you
have to configure the SystemTimeout value again. The default factory setting of
SystemTimeout value should be 300000ms (= 300 seconds).
Example:
Command
Argument
Description
config
= RESET
Clears the settings in the EEPROM.
After reboot, the firmware will use the new (default) settings on
EEPROM.
Note: ("RESET" MUST be in capital letters.)
ГК
Атлант
Инжиниринг
–
официальный
представитель
в
РФ
и
СНГ
+7(495)109-02-08 [email protected] www.bbrc.ru