8
Getting Started:
PAC-5007(P)/5107(P)/5207/5307 Ver. 1.0, 07/2010 ICP DAS
Ebus
To exchange data between ICP DAS’s ISaGRAF Ethernet PACs via Ethernet
port.
Send E-mail
Actively or passively sending E-mail via Ethernet port through internet.
Max.10 receivers for each sending and can send E-mail with an attached
file. (Max. file size is about 488 KB)
SMS: Short Message
Service
One of (COM1 or COM3: RS-232 in-XW-Board) can link to a GSM modem
to support SMS. User can request data/control the controller by cellular
phone. The controller can also send data & alarms to user's cellular phone.
Optional GSM modem: GTM-201-RS232 (GSM/GPRS 850/900/1800/1900)
Note: μPAC-5207, 5307 has built-in GPRS, no external GSM/GPRS modem
required.
User-defined Protocol
User can write his own protocol applied at COM1, COM2 & (COM3 ~
COM8 -in-XW-Board) by serial communication function blocks.
MMICON/LCD
One of (COM3: RS-232 in-XW-Board) supports ICP DAS's MMICON. The
MMICON is featured with a 240 x 64 dot LCD and a 4 x 4 Keyboard. User
can use it to display picture, string, integer, float, and input a character,
string, integer and float.
Redundant Solution
Two PACs plug with
XW107
in slot0. One is Master, one is Slave. Master
handles all inputs & outputs at run time. If Master is damaged (or power
off), Slave will take over the control of Bus7000b. If Master is alive from
damaged (or power up again), it takes the control of Bus7000b again. The
change over time is about 5 seconds. Control data is exchanging via Ebus
(if using a cross cable, no require any Ethernet Switch). All I/O should be
RS-485 I/O except the status I/O in the slot 0: XW107.
CAN/CANopen
Use COM1 or COM3 ~ COM8 (at the XW5xx RS-232 X-board) to connect
one I-7530: the RS-232 to CAN converter to support CAN/CANopen devices
and sensors. One PAC supports max.
3
RS-232 ports to connect max.
3
I-7530
modules. Please refer to:
www.icpdas.com > FAQ > Software > ISaGRAF Ver.3 (English)
Summary of Contents for I-8417
Page 46: ......
