I-7530 RS-232/CAN Converter User’s Manual (Version 2.5, Mar/2012) ------------- 19
3.3 Test I-7530 on CAN network (Only for normal mode)
The following procedure will guide you to learning how to
transmit/receive CAN messages to/from other devices/PCs by using the I-
7530 converter. Note that users can only employ this test function for the
system if they are using the default communication parameters for the RS-
232 as provided above.
1. Set the Init/Normal switch to the Normal position, which is found at the
back of the I-7530 module.
2. Connect the I-7530’s CAN port into the CAN network, which must at
least have one CAN device on the network.
3. Supply the 10~30 volts DC source into the I-7530 module through the
power terminal.
4. The ON LED on the I-7530 module will be turned on. That means the I-
7530 is working in the operation mode.
5. Run the I-7530 Utility software after there is a wire connection as shown
in Section 2.5.
6. Select the “Test” tab and click the “Connect” icon on the tool bar in the
I-7530 Utility to configure the PC COM port and Baud rate, which will be
used to connect to the COM port of the I-7530.
