ICP DAS USA I-7000 Series Quick Start Download Page 2

Page: 2 / 4

Switch to Init Mode

Before attempting to configure the module,
ensure that you move the switch to the

“

Init

”

position, or connect the Init pin to the

GND pin and then power on the module to
access the configuration mode.

Connect to the PC and the Power Supply

Note:

You should only connect a single I-7000/M-7000 module to the
RS-485 bus during the configuration process.

1) Using an RS-232 to RS-485 Converter

2) Using a USB to RS-485 Converter

Power Supply (+24v, GND)

USB

(+Vs, GND)

I-7000/M-7000

RS-485

( Data+, Data- )

I-7561U/tM-7561

INIT

GND

RS-232

Power Supply (+24v, GND)

I-7000/M-7000

(+Vs, GND)

RS-485

( Data+, Data- )

I-7520/tM-7520U

Summary of Contents for I-7000 Series

Page 1: ...M 7018Z G S and M 7019Z G S DN 1822 and CA 252518D 1 are for I 7018Z G S2 M 7018Z G S2 and M 7019Z G S2 DN 1823 and CA 2525015D are for I 7018Z G S3 M 7018Z G S3 and M 7019Z G S3 DN 8P8C CA 090910 A a...

Page 2: ...guration mode 2 Connect to the PC and the Power Supply Note You should only connect a single I 7000 M 7000 module to the RS 485 bus during the configuration process 1 Using an RS 232 to RS 485 Convert...

Page 3: ...DCON Utility Pro The DCON Utility Pro can be obtained via FTP from the address below or by scanning the QR code http ftp icpdas com pub cd 8000cd napdos driver dcon_utility 4 Set the Communication Pa...

Page 4: ...ition or disconnect the INIT to the GND then reboot the module to apply the new configuration Also search for the module again to confirm that the new configuration is correct and that the module can...