HRT-711 Modbus TCP to HART Gateway
- QuickStart (Jan/2018)
ICP DAS USA, Inc.
|
www.icpdas-usa.com
| 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717
3
-
Jumper
Jumper
Description
JP2
Enable/Disable hardware WDT. (Default setting is enable)
NOTE: Please do not disable the hardware WDT.
JP3
For updating firmware. (Default setting is on 1 and 2)
NOTE: Please do not switch to 2 and 3 when in normal operation.
The jumper can provide HART bus with 250 Ω (1/4 W) resistor. When
the pin 1&2 of JP4 is closed, the resistor will connect to HART bus.
JP4
When the pin 2&3 of JP4 is closed or JP4 without jumper connected, it
will disconnect the resistor from HART bus. By default, the pin1&2 of
JP4 is closed.
-
LED Indicator
LED
Status
Description
Blink
Blink every 0.2 second
：
Receiving Ethernet packet
ETH
Blink every 3 second
：
The network function is normal
Off
Ethernet Error
Blink every 1 second
：
Blink
The HRT-711 is in the initialing procedure
Blink every 0.5 second
：
HART
The HRT-711 is handling the burst frame sent from
HART device
Solid
The HRT-711 is in the normal status
Off
Firmware is not loaded
ERR
Blink
HART communication error
Off
HART communication is good
