HRT-227CS, HART to Single Mode Fiber Converter (version 1.00)
–
2015/02/02
Page: 5
Copyright © 20
15 ICP DAS Co., Ltd. All Rights Reserved. E-mail: [email protected]
1.1. Specifications
HART Interface
Channel
1
Connector
2-pin screwed terminal block (HART+, HART-)
Terminator Resistor
Selectable 250
Ω loop resistor
HART Data
Only Digital Data
Isolation
UL1577 Spec.
Fiber Interface
Type
SC Duplex type ; Single mode ; 100 Base-FX
Wave Length (nm)
1310
Fiber Cable (μm)
8.3/125, 8.7/125, 9/125 or 10/125
Transmission Distance (km) 30 (indicative only)
Min./Max. TX Output (dBm) -15 / -8
Max. RX Sensitivity (dBm)
-34
Max. RX Overload (dBm)
-5
Budget (dBm)
19
UART Interface
COM
RS-232 (TXD / RXD / GND) for configuration (1200, O, 8 ,1)
LED
Round LED
PWR, FB_Ack, FB_Err, HT_Err, HT_Tx and HT_Rx
Power
Power supply
Unreg10 ~ +30 VDC
Protection
Power reverse polarity / Over-voltage brown-out protection
Power Consumption
3W
Mechanism
Installation
DIN-Rail
Dimensions
33.0 mm x 126 mm x 101 mm (W x L x H)
Environment
Operating Temperature
-25 to 75 °C
Storage Temperature
-30 to 80 °C
Humidity
10 to 90% RH, non-condensing
ГК
Атлант
Инжиниринг
–
официальный
представитель
в
РФ
и
СНГ
+7(495)109-02-08 [email protected] www.bbrc.ru
