ICP DAS USA FSM-510G series, User Manual, Page: 8 / 99

8
Ethernet
Operating mode Store and forward, L2 wire-speed/non-blocking switching
engine
MAC addresses 8K
Jumbo frames 9K Bytes
Copper RJ45 Ports
Speed 10/100/1000 Mbps
MDI/MDIX Auto-crossover Support straight or cross wired cables
Auto-negotiating 10/100/1000 Mbps speed auto-negotiation; Full and half
duplex
Ethernet isolation 1500 VRMS 1 minute
SFP (pluggable) Ports
Port types supported SFP (pluggable) Ports 100/1000Base SFP slot
Support 100/1000BaseT SFP transceiver
Fiber port connector LC typically for fiber (depends on module)
Optimal fiber cable Typical 50 or 62.5/125 μm for multimode (mm);
Typical 8 or 9/125 μm for single mode (sm)
Network Redundancy
Fast failover protection rings Link loss recovery < 20ms
Single & Multiple rings supported
Spanning Tree Protocol IEEE 802.1D STP, IEEE 802.1w RSTP, IEEE 802.1s MSTP
Port Trunk with LACP Static trunk or Dynamic via LACP (Link Aggregation Control
Protocol)
Bridge, VLANs & Protocols
Flow control IEEE 802.3x (Full Duplex) and Back-Pressure(Half Duplex)
VLAN Types Port-based VLANs
IEEE 802.1Q tag-based VLANs
IEEE 802.1ad Double Tagging (Q in Q)
Multicast protocols IGMP v1, v2
IGMP snooping and querying
Immediate leave and leave proxy
Throttling and filtering
LLDP IEEE 802.1ab Link layer Discovery Protocol (LLDP)
Traffic management & QoS
Priority IEEE 802.1p QoS
Number of queues per port 8
Scheduling schemes SPQ, WRR
Traffic Shaper port-based shaping
Security
Port security IP and MAC-based access control
IEEE 802.1X authentication Network Access Control
Storm Control Multicast/Broadcast/Flooding Storm Control
Power
Power input
Redundant Input Terminals
Input voltage range
Max. power consumption 12-58 VDC
10.5W
Reverse power protection
Yes
Indicators
Power Status indication
Indication of power input status
Ethernet port indication
Link & Speed